Cisco 2431 - IAD Router User Manual

3-12
Cisco IAD2430 Series Integrated Access Devices Software Configuration Guide
OL-4306-03
Chapter 3 Configuring with the Command-Line Interface
Configuring T1/E1 Interfaces
Configuring Switch Types for ISDN PRI Q.931 Support
Perform the following steps to configure Q Signalling (QSIG) signaling support on Cisco IAD2430
series IADs.
SUMMARY STEPS
1. enable
2. configure terminal
3. isdn switch-type primary
4. controller t1/e1 slot/port
5. pri-group timeslots range
6. isdn protocol-emulate {user|network}
7. no line-power
8. isdn incoming-voice voice
9. exit
10. Ctrl-z
DETAILED STEPS
Command or Action Purpose
Step 1
enable
Example:
Router# enable
Enters privileged EXEC mode.
Step 2
configure terminal
Example:
Router# configure terminal
Enters global configuration mode.
Step 3
isdn switch-type primary
Example:
Router(config)# isdn switch-type primary-net5
(Optional; see note.) Selects a service provider switch
type that accommodates PRI.
Note You can configure the ISDN switch type in either
global or interface configuration mode.
If you configure the switch type here, specify the switch
type for all PRI ports.
If you configure the switch type on a single interface,
specify the switch type for that interface. The switch type
specified for any individual interface overrides the
globally specified switch type.
Step 4
controller t1/e1 slot/port
Example:
Router(config)# controller t1 0/2
Enters controller configuration mode for the controller at
the specified slot/port location. Valid values for slot and
port are 0 and 1.

Cisco 2431 - IAD Router Specifications

General

Brand	Cisco
Model	2431 - IAD Router
Category	Network Hardware
Language	English