EasyManuals Logo

Cisco 3905 Administration Guide

Cisco 3905
136 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #120 background imageLoading...
Page #120 background image
Five-digit internal telephone number: 26640
Cisco Unified Communications Manager User Addition
This section describes steps for adding a user to Cisco Unified Communications Manager. Follow one of the
procedures in this section, depending on your operating system and the manner in which you are adding the
user:
Add User from External LDAP Directory
If you added a user to an LDAP Directory (a non-Cisco Unified Communications Server directory), you can
immediately synchronize that directory to the Cisco Unified Communications Manager on which you are
adding this same user and the users phone by following these steps:
Procedure
Step 1
Login to Cisco Unified Communications Manager Administration.
Step 2
Choose System > LDAP > LDAP Directory.
Step 3
Use Find to locate your LDAP directory.
Step 4
Click the LDAP directory name.
Step 5
Click Perform Full Sync Now.
If you do not need to immediately synchronize the LDAP Directory to the Cisco Unified
Communications Manager, the LDAP Directory Synchronization Schedule on the LDAP Directory
window determines when the next auto-synchronization is scheduled. However, the synchronization
must occur before you can associate a new user to a device.
Note
Step 6
Proceed to Phone Setup, on page 107.
Add User Directly to Cisco Unified Communications Manager
If you are not using an LDAP directory, you can add a user directly to Cisco Unified Communications Manager
Administration by following these steps:
Procedure
Step 1
Choose User Management > End User.
Step 2
Click Add New.
The End User Configuration window appears.
Step 3
In the User Information pane of this window, enter the following:
User ID: Enter the end user identification name. Cisco Unified Communications Manager does not
permit modifying the user ID after it is created. You may use the following special characters: =, +, <,
>, #, ;, \, , "", and blank spaces.
Cisco Unified SIP Phone 3905 Administration Guide for Cisco Unified Communications Manager 8.6 (SIP)
106
Basic Phone Administration Steps
Cisco Unified Communications Manager User Addition

Table of Contents

Other manuals for Cisco 3905

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco 3905 and is the answer not in the manual?

Cisco 3905 Specifications

General IconGeneral
SpeakerphoneYes
Ethernet SwitchNo
HandsetStandard
Protocol SupportSIP
Lines1
Headset PortNo
Power over Ethernet (PoE)IEEE 802.3af Class 1
Ethernet Ports2

Related product manuals