Cisco 3905 Administration Guide

Table 5: Methods for Adding Phones to the Cisco Unified Communications Manager Database
NotesRequires MAC
Address?
Method
•
Results in automatic assignment of directory numbers
•
Not available when security or encryption is enabled.
NoAuto-registration
Requires auto-registration and the Bulk Administration Tool
(BAT); updates information in the Cisco Unified IP Phone
and in Cisco Unified Communications Manager
Administration
NoAuto-registration with
TAPS
Requires phones to be added individuallyYesUsing the Cisco Unified
Communications Manager
Administration
Allows for simultaneous registration of multiple phonesYesUsing BAT
Autoregistration Phone Addition
By enabling auto-registration before you begin installing phones, you can:
•
Add phones without first gathering MAC addresses from the phones.
•
Automatically add a Cisco Unified IP Phone to the Cisco Unified Communications Manager database
when you physically connect the phone to your IP telephony network. During auto-registration,
Cisco Unified Communications Manager assigns the next available sequential directory number to the
phone.
•
Quickly enter phones into the Cisco Unified Communications Manager database and modify any settings,
such as the directory numbers, from Cisco Unified Communications Manager.
•
Move auto-registered phones to new locations and assign them to different device pools without affecting
their directory numbers.
Cisco recommends you use auto-registration to add less than 100 phones to your network. To add more
than 100 phones to your network, use the Bulk Administration Tool (BAT).
Note
Auto-registration is disabled by default. In some cases, you might not want to use auto-registration; for
example, if you want to assign a specific directory number to the phone. For information about enabling
auto-registration, see the “Enabling Auto-Registration” section in the Cisco Unified Communications Manager
Administration Guide.
Cisco Unified SIP Phone 3905 Administration Guide for Cisco Unified Communications Manager 8.6 (SIP)
27
Cisco Unified IP Phone and Your Network
Autoregistration Phone Addition

Cisco 3905 Specifications

General

Speakerphone	Yes
Ethernet Switch	No
Handset	Standard
Protocol Support	SIP
Lines	1
Headset Port	No
Power over Ethernet (PoE)	IEEE 802.3af Class 1
Ethernet Ports	2