Cisco 3905 Administration Guide

Possible Explanation and ActionDescriptionMessage
From Cisco Unified Operating System
Administration, make sure that the phone load
file is on the TFTP server, and that the entry
in the configuration file is correct.
The phone cannot locate, on the
TFTP server, the phone load file
that is specified in the phone
configuration file.
File not found
The phone remains idle until it is power cycled
or you reset the DHCP address.
The phone has been configured to
release its IP address.
IP address released
Check the load ID assigned to the phone (from
Cisco Unified Communications Manager,
choose Device > Phone). Verify that the load
ID is entered correctly.
Load ID of the software file is of
the wrong type.
Load ID incorrect
Occurs if you were attempting to install a
version of software on this phone that did not
support hardware changes on this newer phone.
Check the load ID assigned to the phone (from
Cisco Unified Communications Manager,
choose Device > Phone ). Re-enter the load
displayed on the phone.
The application that was
downloaded is not compatible with
the phone’s hardware.
Load rejected HC
•
If the phone has a static IP address, verify
that the default router has been
configured.
•
If you are using DHCP, the DHCP server
has not provided a default router. Check
the DHCP server configuration.
DHCP or static configuration did
not specify a default router.
No default router
•
If the phone has a static IP address, verify
that the DNS server has been configured.
•
If you are using DHCP, the DHCP server
has not provided a DNS server. Check
the DHCP server configuration.
A name was specified but DHCP
or static IP configuration did not
specify a DNS server address.
No DNS server IP
•
If you are using DHCP, verify that the
DHCP server is pointing to the correct
TFTP server.
•
If you are using static IP addresses, check
the TFTP server configuration.
TFTP server is pointing to a
directory that does not exist.
TFTP access error
Contact the Cisco TAC.The phone does not recognize an
error code provided by the TFTP
server.
TFTP error
Cisco Unified SIP Phone 3905 Administration Guide for Cisco Unified Communications Manager 8.6 (SIP)
74
Remote Monitoring
Status Messages

Cisco 3905 Specifications

General

Speakerphone	Yes
Ethernet Switch	No
Handset	Standard
Protocol Support	SIP
Lines	1
Headset Port	No
Power over Ethernet (PoE)	IEEE 802.3af Class 1
Ethernet Ports	2