Cisco 3905 Administration Guide

Model Information Settings Fields
The following table describes the Model Information Settings fields.
Table 10: Model Information Settings for the Cisco Unified SIP Phone 3905
To ChangeDescriptionOption
Display only - cannot configure.Model number of the phone.Model Number
Display only - cannot configure.MAC address of the phone.MAC Address
Display only - cannot configure.Version of firmware currently installed
on the phone.
Active Load ID
Display only - cannot configure.Identifier of the factory-installed load
running on the phone.
Boot Load ID
Display only - cannot configure.IP address of the phone.IP Address
Display only - cannot configure.IP address or name of the server to
which the phone is registered.
Active Server
Display only - cannot configure.IP address or name of the standby
server.
Stand-by Server
Status Menu
The Status menu includes theses options, which provide information about the phone and its operation:
•
Network Statistics: Displays the Network Statistics screen, which shows Ethernet traffic statistics.
•
Call Statistics: Displays counters and statistics for the current call.
Display Status Menu
To display the Status menu, perform these steps.
Procedure
Step 1
Press Applications.
Step 2
Select Admin Settings > Status.
Step 3
To exit the Status menu, press Back .
Cisco Unified SIP Phone 3905 Administration Guide for Cisco Unified Communications Manager 8.6 (SIP)
58
Model Information, Status, and Statistics
Model Information Settings Fields

Cisco 3905 Specifications

General

Speakerphone	Yes
Ethernet Switch	No
Handset	Standard
Protocol Support	SIP
Lines	1
Headset Port	No
Power over Ethernet (PoE)	IEEE 802.3af Class 1
Ethernet Ports	2