Wall mount
You can mount the Cisco Unified SIP Phone 3905 on the wall by using a standard telephone wall plate with
an opening for an RJ-45 connector. Cisco recommends that you use Leviton Wall Mount plate (Leviton type
number: 4108W-0SP) to wall mount the Cisco Unified SIP Phone 3905. For information on installing the
wall mount kit for Cisco Unified SIP Phone 3905, see Items Required for Wall Mount, on page 111.
Phone Startup Verification
The LEDs on the MWI on the phone light up during bootup. Upon successful completion of the bootup process,
the LEDs turn off, and the phone is ready for calls. If the phone successfully boots up, it has started up properly.
If the phone does not start up properly, the user receives a notification on the phone screen. For more
information, see the Startup Problems, on page 79.
Network Settings Without DHCP
If you are not using DHCP in your network, you must configure these network settings on the
Cisco Unified IP Phone after installing the phone on the network:
•
IP address
•
IP subnet information
•
Default Router
•
TFTP server IP address
Collect this information and see the instructions in Cisco Unified IP Phone Settings, on page 35.
Cisco Unified SIP Phone 3905 Administration Guide for Cisco Unified Communications Manager 8.6 (SIP)
34
Cisco Unified IP Phone Installation
Wall mount
To Next Page
Loading...
Need help?
General
