Cisco 6000 series User Manual

Carrier Delay on Ethernet Interfaces 32
How to Configure Ethernet 33
Configuring Ethernet Interfaces 33
Configuring Gigabit Ethernet Interfaces 33
What to Do Next 36
What to Do Next 36
Configuring MAC Accounting on an Ethernet Interface 36
Configuring a L2VPN Ethernet Port 38
What to Do Next 40
Configuring LLDP 40
LLDP Default Configuration 40
Enabling LLDP Globally 40
Configuring Global LLDP Operational Characteristics 41
Disabling Transmission of Optional LLDP TLVs 41
Disabling LLDP Receive and Transmit Operations for an Interface 41
Verifying the LLDP Configuration 43
Configuration Examples for Ethernet 44
Configuring an Ethernet Interface: Example 44
Configuring MAC-Accounting: Example 44
Configuring a Layer 2 VPN AC: Example 45
Configuring LLDP: Examples 45
Where to Go Next 45
Additional References 45
Configuring Ethernet OAM 47
CHAPTER 5
Prerequisites for Configuring Ethernet OAM 47
Information About Configuring Ethernet OAM 47
Ethernet Link OAM 47
Neighbor Discovery 48
Link Monitoring 48
MIB Retrieval 48
Miswiring Detection (Cisco-Proprietary) 48
SNMP Traps 48
How to Configure Ethernet OAM 49
Interface and Hardware Component Configuration Guide for Cisco NCS 6000 Series Routers, IOS XR Release 6.4.x
v
Contents

Cisco 6000 series Specifications

General

Category	Network Router
Model	Cisco 6000 series
Routing Protocols	BGP, OSPF, EIGRP, IS-IS, RIP
Interfaces	Gigabit Ethernet, 10 Gigabit Ethernet
Ports	Varies by model
Power Supply	Redundant power supply options
Dimensions	Varies by model
Weight	Varies by model
Redundancy	Power supplies, fans, route processors
Operating System	Cisco IOS