Cisco 6000 series User Manual

PurposeCommand or Action
Specifies the action that is taken on an interface when a
dying-gasp notification is received from the remote
action dying-gasp {disable | error-disable-interface}
Example:
Step 23
Ethernet OAM peer. The default action is to create a syslog
entry.
RP/0/RP0/CPU0:router(config-eoam)# action
dying-gasp error-disable-interface
• If you change the default, the log keyword
option is available in Interface Ethernet
OAM configuration mode to override the
profile setting and log the event for the
interface when it occurs.
Note
Specifies the action that is taken on an interface when a
high threshold is exceeded. The default is to take no action
when a high threshold is exceeded.
action high-threshold {error-disable-interface | log}
Example:
RP/0/RP0/CPU0:router(config-eoam)# action
high-threshold error-disable-interface
Step 24
• If you change the default, the disable
keyword option is available in Interface
Ethernet OAM configuration mode to
override the profile setting and take no
action at the interface when the event
occurs.
Note
Specifies that no action is taken on an interface when a
remote-loopback event occurs. The default action is to
create a syslog entry.
action remote-loopback disable
Example:
RP/0/RP0/CPU0:router(config-eoam)# action
remote-loopback disable
Step 25
• If you change the default, the log keyword
option is available in Interface Ethernet
OAM configuration mode to override the
profile setting and log the event for the
interface when it occurs.
Note
Specifies the action that is taken on an interface when an
Ethernet OAM session goes down.
action session-down {disable | efd |
error-disable-interface}
Step 26
Example:
• If you change the default, the log keyword
option is available in Interface Ethernet
OAM configuration mode to override the
profile setting and log the event for the
interface when it occurs.
Note
RP/0/RP0/CPU0:router(config-eoam)# action
session-down efd
Specifies that no action is taken on an interface when an
Ethernet OAM session is established. The default action
is to create a syslog entry.
action session-up disable
Example:
RP/0/RP0/CPU0:router(config-eoam)# action
session-up disable
Step 27
Interface and Hardware Component Configuration Guide for Cisco NCS 6000 Series Routers, IOS XR Release 6.4.x
54
Configuring Ethernet OAM
Configuring an Ethernet OAM Profile

Cisco 6000 series Specifications

General

Category	Network Router
Model	Cisco 6000 series
Routing Protocols	BGP, OSPF, EIGRP, IS-IS, RIP
Interfaces	Gigabit Ethernet, 10 Gigabit Ethernet
Ports	Varies by model
Power Supply	Redundant power supply options
Dimensions	Varies by model
Weight	Varies by model
Redundancy	Power supplies, fans, route processors
Operating System	Cisco IOS