Cisco 6000 series User Manual

PurposeCommand or Action
Requires that active mode or passive mode is configured
on the remote end before the OAM session becomes active.
require-remote mode {active|passive}
Example:
Step 17
RP/0/RP0/CPU0:router(config-eoam)# require-remote
mode active
Requires that link-monitoring is configured on the remote
end before the OAM session becomes active.
require-remote link-monitoring
Example:
Step 18
RP/0/RP0/CPU0:router(config-eoam)# require-remote
link-monitoring
Requires that MIB-retrieval is configured on the remote
end before the OAM session becomes active.
require-remote mib-retrieval
Example:
Step 19
RP/0/RP0/CPU0:router(config-eoam)# require-remote
mib-retrieval
Specifies the action that is taken on an interface when a
capabilities-conflict event occurs. The default action is to
create a syslog entry.
action capabilities-conflict {disable | efd |
error-disable-interface}
Example:
Step 20
• If you change the default, the log keyword
option is available in Interface Ethernet
OAM configuration mode to override the
profile setting and log the event for the
interface when it occurs.
Note
RP/0/RP0/CPU0:router(config-eoam)# action
capabilities-conflict efd
Specifies the action that is taken on an interface when a
critical-event notification is received from the remote
action critical-event {disable | error-disable-interface}
Example:
Step 21
Ethernet OAM peer. The default action is to create a syslog
entry.
RP/0/RP0/CPU0:router(config-eoam)# action
critical-event error-disable-interface
• If you change the default, the log keyword
option is available in Interface Ethernet
OAM configuration mode to override the
profile setting and log the event for the
interface when it occurs.
Note
Specifies the action that is taken on an interface when a
connection timeout occurs. The default action is to create
a syslog entry.
action discovery-timeout {disable | efd |
error-disable-interface}
Example:
Step 22
• If you change the default, the log keyword
option is available in Interface Ethernet
OAM configuration mode to override the
profile setting and log the event for the
interface when it occurs.
Note
RP/0/RP0/CPU0:router(config-eoam)# action
discovery-timeout efd
Interface and Hardware Component Configuration Guide for Cisco NCS 6000 Series Routers, IOS XR Release 6.4.x
53
Configuring Ethernet OAM
Configuring an Ethernet OAM Profile

Cisco 6000 series Specifications

General

Category	Network Router
Model	Cisco 6000 series
Routing Protocols	BGP, OSPF, EIGRP, IS-IS, RIP
Interfaces	Gigabit Ethernet, 10 Gigabit Ethernet
Ports	Varies by model
Power Supply	Redundant power supply options
Dimensions	Varies by model
Weight	Varies by model
Redundancy	Power supplies, fans, route processors
Operating System	Cisco IOS