Cisco 6000 series User Manual

PurposeCommand or Action
If you do not specify the mode keyword, the
default mode is on (LACP is not run over the
port).
Note
(Optional) If you set the bundle maximum-active links
command to 1, you must also set the priority of the active
bundle port-priority priority
Example:
Step 11
link to the highest priority (lowest value) and the standby
RP/0/RP0/CPU0:router(config-if)# bundle
port-priority 1
link to the second-highest priority (next lowest value). For
example, you can set the priority of the active link to 1 and
the standby link to 2.
(Optional) If a link is in the down state, bring it up. The
no shutdown command returns the link to an up or down
state depending on the configuration and state of the link.
no shutdown
Example:
RP/0/RP0/CPU0:router(config-if)# no shutdown
Step 12
Exits interface configuration submode for the Ethernet
interface.
exit
Example:
Step 13
RP/0/RP0/CPU0:router(config-if)# exit
(Optional) Repeat Step 8 through Step 11 to add more links
to the bundle.
interface {TenGigE} number
Example:
Step 14
bundle id bundle-id
[mode {active
|
passive
|
on}]
Example:
no shutdown
Example:
exit
Example:
RP/0/RP0/CPU0:router(config)# interface TenGigE
1/0/2/1
Example:
RP/0/RP0/CPU0:router(config-if)# bundle id 3
Example:
Example:
Interface and Hardware Component Configuration Guide for Cisco NCS 6000 Series Routers, IOS XR Release 6.4.x
74
Configuring Link Bundling
Configuring Ethernet Link Bundles

Cisco 6000 series Specifications

General

Category	Network Router
Model	Cisco 6000 series
Routing Protocols	BGP, OSPF, EIGRP, IS-IS, RIP
Interfaces	Gigabit Ethernet, 10 Gigabit Ethernet
Ports	Varies by model
Power Supply	Redundant power supply options
Dimensions	Varies by model
Weight	Varies by model
Redundancy	Power supplies, fans, route processors
Operating System	Cisco IOS