Cisco 6000 series User Manual

PurposeCommand or Action
RP/0/RP0/CPU0:router(config-if)# bundle
port-priority 2
Example:
RP/0/RP0/CPU0:router(config-if)# no shutdown
Example:
Example:
RP/0/RP0/CPU0:router(config-if)# exit
Example:
Example:
RP/0/RP0/CPU0:router(config)# interface TenGigE
1/0/2/3
Example:
Example:
RP/0/RP0/CPU0:router(config-if)# bundle id 3
Example:
Example:
RP/0/RP0/CPU0:router(config-if)# no shutdown
Example:
Example:
RP/0/RP0/CPU0:router(config-if)# exit
Saves configuration changes.Do one of the following:
Step 15
• end • When you issue the end command, the system
prompts you to commit changes:
•
• commit
Uncommitted changes found, commit them before
Example:
exiting(yes/no/cancel)?
[cancel]:
RP/0/RP0/CPU0:router(config-if)# end
• • Entering yes saves configuration changes to the
running configuration file, exits the configuration
Example:
session, and returns the router to XR EXEC
mode.
Example:
Interface and Hardware Component Configuration Guide for Cisco NCS 6000 Series Routers, IOS XR Release 6.4.x
75
Configuring Link Bundling
Configuring Ethernet Link Bundles

Cisco 6000 series Specifications

General

Category	Network Router
Model	Cisco 6000 series
Routing Protocols	BGP, OSPF, EIGRP, IS-IS, RIP
Interfaces	Gigabit Ethernet, 10 Gigabit Ethernet
Ports	Varies by model
Power Supply	Redundant power supply options
Dimensions	Varies by model
Weight	Varies by model
Redundancy	Power supplies, fans, route processors
Operating System	Cisco IOS