Ultimate disposal of this product should be handled according to all national laws and regulations.
Statement 1040
Warning
Installation of the equipment must comply with local and national electrical codes. Statement 1074
Warning
Power cable and AC adapter - When installing the product, please use the provided or designated
connection cables/power cables/AC adaptors. Using any other cables or adapters could cause a malfunction
or a fire. Electrical Appliance and Material Safety Law prohibits the use of certified cables (that have
the ‘UL’ shown on the code) for any other electrical devices than products designated by Cisco. The
use of cables that are certified by Electrical Appliance and Material Safety Law (that have ‘PSE’ shown
on the code) is not limited to Cisco-designated products. Statement 371
Warning
Only trained and qualified personnel should be allowed to install or replace this equipment. Statement
1030
Warning
This product relies on the building’s installation for short-circuit (overcurrent) protection. Ensure that
the protective device is rated not greater than 20A. Statement 1005
Warning
This unit may have more than one power supply connection. All connections must be removed to
de-energize the unit. Statement 1028
Warning
Restricted Area
This unit is intended for installation in restricted access areas. A restricted access area can be accessed
by skilled, instructed or qualified personnel. Statement 1017
Warning
Use copper conductors only. Statement 1025
Warning
This equipment must be grounded. Never defeat the ground conductor or operate the equipment in the
absence of a suitably installed ground conductor. Contact the appropriate electrical inspection authority
or an electrician if you are uncertain that suitable grounding is available. Statement 1024
Warning
Hardware Installation Guide for Cisco Catalyst 8300 Series Edge Platforms
16
Prepare for Installation
General Safety Warnings
To Next Page
Loading...
Need help?
General
