Cisco Catalyst 8300 Series

• Position the cables carefully, so that they do not put strain on the connectors.
• Organize cables in bundles so that cables do not intertwine.
• Inspect the cables to make sure that the routing and bend radius is satisfactory. Reposition cables, if
necessary.
• Install cable ties in accordance with site requirements.
For cable pinouts, see Cisco Modular Access Cable Specifications.
After installing the device and connecting the cables, you can configure the device with basic
configurations. For more information on how to configure the device, see the Cisco Catalyst 8300 Series
Edge Platforms Software Configuration Guide.
Note
Hardware Installation Guide for Cisco Catalyst 8300 Series Edge Platforms
53
Install and Connect
Connection Procedures and Precautions