Cisco Catalyst 9400

PurposeCommand or Action
Device# configure terminal
Disables message logging.no logging console
Example:
Step 2
Device(config)# no logging console
Returns to privileged EXEC mode.end
Example:
Step 3
Device(config)# end
Enabling and Disabling Time Stamps on Log Messages
By default, log messages are not time-stamped.
This task is optional.
Procedure
PurposeCommand or Action
Enters global configuration mode.configure terminal
Example:
Step 1
Device# configure terminal
Enables log time stamps.Use one of these commands:
Step 2
• service timestamps log uptime • log uptime—Enables time stamps on log
messages, showing the time since the
system was rebooted.
• service timestamps log datetime[msec |
localtime | show-timezone]
• log datetime—Enables time stamps on log
messages. Depending on the options
Example:
Device(config)# service timestamps log
uptime
selected, the time stamp can include the
date, time in milliseconds relative to the
local time zone, and the time zone name.
or
Device(config)# service timestamps log
datetime
Returns to privileged EXEC mode.end
Example:
Step 3
System Management Configuration Guide, Cisco IOS XE Bengaluru 17.4.x (Catalyst 9400 Switches)
265
Configuring System Message Logs
Enabling and Disabling Time Stamps on Log Messages