Cisco Catalyst 9400

PurposeCommand or Action
Device(config)# end
Enabling and Disabling Sequence Numbers in Log Messages
If there is more than one log message with the same time stamp, you can display messages with sequence
numbers to view these messages. By default, sequence numbers in log messages are not displayed.
This task is optional.
Procedure
PurposeCommand or Action
Enters global configuration mode.configure terminal
Example:
Step 1
Device# configure terminal
Enables sequence numbers.service sequence-numbers
Example:
Step 2
Device(config)# service sequence-numbers
Returns to privileged EXEC mode.end
Example:
Step 3
Device(config)# end
Defining the Message Severity Level
Limit messages displayed to the selected device by specifying the severity level of the message.
This task is optional.
Procedure
PurposeCommand or Action
Enters global configuration mode.configure terminal
Example:
Step 1
Device# configure terminal
System Management Configuration Guide, Cisco IOS XE Bengaluru 17.4.x (Catalyst 9400 Switches)
266
Configuring System Message Logs
Enabling and Disabling Sequence Numbers in Log Messages