Cisco Catalyst 9400 User Manual

Example: Configuring Unicast MAC Address Filtering
This example shows how to enable unicast MAC address filtering and how to configure drop packets that
have a source or destination address of c2f3.220a.12f4. When a packet is received in VLAN 4 with this MAC
address as its source or destination, the packet is dropped:
Device(config)# mac address-table static c2f3.220a.12f4 vlan 4 drop
Additional References for Device Administration
Related Documents
Document TitleRelated Topic
Command Reference (Catalyst 9400 Series
Switches)
For complete syntax and usage information for the
commands used in this chapter.
Feature History for Device Administration
This table provides release and related information for features explained in this module.
These features are available on all releases subsequent to the one they were introduced in, unless noted
otherwise.
Feature InformationFeatureRelease
The device administration allows to configure the
system time and date, system name, a login banner,
and set up the DNS.
Device AdministrationCisco IOS XE Everest 16.6.1
Use Cisco Feature Navigator to find information about platform and software image support. To access Cisco
Feature Navigator, go to http://www.cisco.com/go/cfn.
System Management Configuration Guide, Cisco IOS XE Bengaluru 17.4.x (Catalyst 9400 Switches)
40
Administering the Device
Example: Configuring Unicast MAC Address Filtering

Cisco Catalyst 9400 Specifications

General

Product Series	Catalyst 9400 Series
Layer	Layer 2/3
Operating System	Cisco IOS XE
Switch Type	Modular
Uplink Interfaces	10 Gigabit Ethernet, 40 Gigabit Ethernet, 100 Gigabit Ethernet
Stacking	No
Form Factor	Modular Chassis
Operating Temperature	0°C to 40°C (32°F to 104°F)
Redundancy	Power supplies
Security Features	MACsec
Management	Cisco DNA Center, CLI, SNMP