Cisco Catalyst 9400

Procedure
PurposeCommand or Action
Enables privileged EXEC mode.enable
Step 1
Example:
Enter your password if prompted.
Device> enable
Enters global configuration mode.configure terminal
Example:
Step 2
Device# configure terminal
Enters global configuration mode.interface interface-id
Example:
Step 3
Device(config)# interface
gigabitethernet1/0/1
Disables NTP packets from being received on
the interface.
[no] ntp disable
Example:
Step 4
Use the no form of this command to re-enable
receipt of NTP packets on an interface.
Device(config-if)# ntp disable
Returns to privileged EXEC mode.end
Example:
Step 5
Device(config-if)# end
Configuring a System Name
Follow these steps to manually configure a system name:
Procedure
PurposeCommand or Action
Enables privileged EXEC mode.enable
Step 1
Example:
• Enter your password if prompted.
Device> enable
System Management Configuration Guide, Cisco IOS XE Bengaluru 17.4.x (Catalyst 9400 Switches)
21
Administering the Device
Configuring a System Name