Cisco Catalyst 9400

Configuring Online Diagnostics
You must configure the failure threshold and the interval between tests before enabling diagnostic monitoring.
Scheduling Online Diagnostics
You can schedule online diagnostics to run at a designated time of day, or on a daily, weekly, or monthly
basis for a device. Use the no form of the diagnostic schedule switch command to remove the scheduling.
Procedure
PurposeCommand or Action
Enters global configuration mode.configure terminal
Example:
Step 1
Device #configure terminal
Schedules on-demand diagnostic test for a
specific day and time.
diagnostic schedule module number test
{name | test-id | test-id-range | all | basic |
Step 2
complete | minimal | non-disruptive |
The switch number keyword is supported only
on stacking switches.
per-port} {daily | on mm dd yyyy hh:mm | port
inter-port-number port-number-list | weekly
day-of-week hh:mm}
When specifying the test to be scheduled, use
these options:
Example:
• name: Name of the test that appears in the
showdiagnostic content command output.
Device(config)# diagnostic schedule
module 3 test 1-5 on July 3 2013 23:10
• test-id: ID number of the test that appears
in the show diagnostic content command
output.
• test-id-range: ID numbers of the tests that
appear in the show diagnostic content
command output.
• all: All test IDs.
• basic: Starts the basic on-demand
diagnostic tests.
• complete: Starts the complete test suite.
• minimal: Starts the minimal bootup test
suite.
• non-disruptive: Starts the nondisruptive
test suite.
• per-port: Starts the per-port test suite.
You can schedule the tests as follows:
• Daily: Use the daily hh:mm parameter.
System Management Configuration Guide, Cisco IOS XE Bengaluru 17.4.x (Catalyst 9400 Switches)
276
Configuring Online Diagnostics
Configuring Online Diagnostics