EasyManuals Logo

Cisco Catalyst 9400 User Manual

Cisco Catalyst 9400
458 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #36 background imageLoading...
Page #36 background image
PurposeCommand or Action
Returns to privileged EXEC mode.end
Example:
Step 5
Device(config)# end
Configuring Broadcast-Based NTP Associations
To configure broadcast-based NTP associations, perform this procedure:
Procedure
PurposeCommand or Action
Enables privileged EXEC mode.enable
Step 1
Example:
Enter your password if prompted.
Device> enable
Enters global configuration mode.configure terminal
Example:
Step 2
Device# configure terminal
Configures an interface and enters interface
configuration mode.
interface interface-id
Example:
Step 3
Device(config)# interface
gigabitethernet1/0/1
Enables the interface to send NTP broadcast
packets to a peer.
[no] ntp broadcast [version number] [key
key-id] [destination-address]
Step 4
Example:
number: NTP version number. The range
is 1 to 3. By default, version 3 is used.
Device(config-if)# ntp broadcast version
key-id: Authentication key.
2
destination-address: IP address of the peer
that is synchronizing its clock to this
switch.
Use the no form of this command to disable the
interface from sending NTP broadcast packets.
Enables the interface to receive NTP broadcast
packets.
[no] ntp broadcast client
Example:
Step 5
System Management Configuration Guide, Cisco IOS XE Bengaluru 17.4.x (Catalyst 9400 Switches)
18
Administering the Device
Configuring Broadcast-Based NTP Associations

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco Catalyst 9400 and is the answer not in the manual?

Cisco Catalyst 9400 Specifications

General IconGeneral
Product SeriesCatalyst 9400 Series
LayerLayer 2/3
Operating SystemCisco IOS XE
Switch TypeModular
Uplink Interfaces10 Gigabit Ethernet, 40 Gigabit Ethernet, 100 Gigabit Ethernet
StackingNo
Form FactorModular Chassis
Operating Temperature0°C to 40°C (32°F to 104°F)
RedundancyPower supplies
Security FeaturesMACsec
ManagementCisco DNA Center, CLI, SNMP

Related product manuals