Cisco Catalyst 9400 User Manual

PurposeCommand or Action
• The revert trigger keywords set the
following triggers for reverting to the
original configuration:
• error —Reverts to the original
configuration upon error.
• timer minutes —Reverts to the
original configuration if specified
time elapses.
• The ignore case keyword allows the
configuration to ignore the case of the
confirmation command.
(Optional) To cancel the timed rollback and
trigger the rollback immediately, or to reset
configure revert { now | timer {minutes | idle
minutes} }
Step 3
parameters for the timed rollback, use the
Example:
conf igure revertcommand in privileged EXEC
mode.
Device# configure revert now
• now —Triggers the rollback immediately.
• timer —Resets the configuration revert
timer.
• Use the minutes argument with the
timer keyword to specify a new
revert time in minutes.
• Use the idle keyword along with a
time in minutes to set the maximum
allowable time period of no activity
before reverting to the saved
configuration.
(Optional) Confirms replacement of the current
running configuration file with a saved Cisco
IOS configuration file.
configure confirm
Example:
Device# configure confirm
Step 4
Use this command only if the time
seconds keyword and argument of
the configure replace command are
specified.
Note
Exits to user EXEC mode.exit
Example:
Step 5
Device# exit
System Management Configuration Guide, Cisco IOS XE Bengaluru 17.4.x (Catalyst 9400 Switches)
332
Configuration Replace and Configuration Rollback
Performing a Configuration Replace or Configuration Rollback Operation

Cisco Catalyst 9400 Specifications

General

Product Series	Catalyst 9400 Series
Layer	Layer 2/3
Operating System	Cisco IOS XE
Switch Type	Modular
Uplink Interfaces	10 Gigabit Ethernet, 40 Gigabit Ethernet, 100 Gigabit Ethernet
Stacking	No
Form Factor	Modular Chassis
Operating Temperature	0°C to 40°C (32°F to 104°F)
Redundancy	Power supplies
Security Features	MACsec
Management	Cisco DNA Center, CLI, SNMP