Cisco Catalyst 9400 User Manual

Device: boot flash:packages.conf
Step 3 Terminate the initial configuration dialog by answering No.
Would you like to enter the initial configuration dialog? [yes/no]: No
Step 4 At the switch prompt, enter privileged EXEC mode.
Device> enable
Device#
Step 5 Copy the startup configuration to running configuration.
Device# copy startup-config running-config Destination filename [running-config]?
Press Return in response to the confirmation prompts. The configuration file is now reloaded, and you can
change the password.
Step 6 Enter global configuration mode and change the enable password.
Device# configure terminal
Device(config)# enable secret password
Step 7 Return to privileged EXEC mode:
Device(config)# exit
Device#
Step 8 Write the running configuration to the startup configuration file.
Device# copy running-config startup-config
Step 9 Confirm that manual boot mode is enabled.
Device# show boot
BOOT variable = flash:packages.conf;
Manual Boot = yes
Enable Break = yes
Step 10 Reload the device.
Device# reload
Step 11 Return the boot loader parameters to their original values.
System Management Configuration Guide, Cisco IOS XE Bengaluru 17.4.x (Catalyst 9400 Switches)
403
Troubleshooting the Software Configuration
Procedure with Password Recovery Enabled

Cisco Catalyst 9400 Specifications

General

Product Series	Catalyst 9400 Series
Layer	Layer 2/3
Operating System	Cisco IOS XE
Switch Type	Modular
Uplink Interfaces	10 Gigabit Ethernet, 40 Gigabit Ethernet, 100 Gigabit Ethernet
Stacking	No
Form Factor	Modular Chassis
Operating Temperature	0°C to 40°C (32°F to 104°F)
Redundancy	Power supplies
Security Features	MACsec
Management	Cisco DNA Center, CLI, SNMP