Configuring Wireless Controller
Configuring 6-GHz Radio Profile
This procedure enables the 6-GHz radio DCA channels in the controller.
The CW9163E AP's 6-GHz radio is enabled for use in AFC approved countries only.
Note
Procedure
Step 1 Log in to the Catalyst 9800 controller.
Step 2 Choose Configuration > Tags & Profiles > RF/Radio.
The RF/Radio page is displayed.
Step 3 In the RF tab, click default-rf-profile-6ghz.
The Edit RF Profile window is displayed.
Step 4 Click RRM > DCA tab.
Step 5 Ensure all the DCA Channels are enabled.
Step 6 Click Update & Apply to Device.
Configuring 6-GHz OFDMA
This procedure enables the 6-GHz radio OFDMA in the controller.
Procedure
Step 1 Log in to the Catalyst 9800 controller.
Step 2 Choose Configuration > Radio Configurations > High Throughput > 5 GHz Band > 11ax.
Step 3 Check Enable 11ax check box.
Step 4 Check the check boxes for the desired MCS/(data rate), or to select all of them, check the Select All check
box.
Step 5 Choose Configuration > Radio Configurations > High Throughput > 6 GHz Band.
Step 6 Check the check boxes for the desired MCS/(data rate), or to select all of them, check the Select All check
box.
Step 7 Click Update & Apply to Device.
Cisco Catalyst Wireless 9163E Access Point Hardware Installation and Deployment Guide
45
Network Deployment
Configuring Wireless Controller
To Next Page
Loading...
