5-7
Installation Guide for Cisco Secure ACS Solution Engine 4.1
OL-9969-03
Chapter 5 Upgrading and Migrating to Cisco Secure ACS Solution Engine 4.1
Upgrade Procedure
Figure 5-5 Appliance Upgrade Page
j. Click Apply Upgrade.
The upgrade utility applies the management software upgrade.
Note This process takes several minutes. The system reboots several times.
Step 6 Download and apply the ACS Software Upgrade package.
a. Go to the /Upgrade package software for appliance ACS 4.1 folder on the upgrade CD.
b. Double-click the autorun.bat icon.
The download utility starts. You are prompted to enter the hostname of IP address of the appliance,
as shown in
Figure 5-1.
c. Enter the hostname or the IP address of the distribution server and then click Install.
The ACS web interface starts.
d. Log in to the web interface.
e. Choose System Configuration > Appliance Upgrade Status.
The Appliance Upgrade page opens, as shown in Figure 5-2.
f. Download and install the software upgrade.
The steps for downloading and installing the software upgrade package are the same as the steps for
installing the management software as described in
Step 5.
Note If you complete the upgrade and the ACS console displays the message Appliance upgrade in
progress
, this indicates that the upgrade progress is hanging.
If this condition occurs, start an ACS console session and enter the command download
[hostAddress]
, where hostAddress can be any IP address. This action releases the ACS
console from the upgrade process.
To Next Page
Loading...
