Cisco CSR 1000v Series User Manual

DescriptionProperty
Designates the management interface for the Cisco
CSR 1000v. The format must be GigabitEthernetx or
GigabitEthernetx.xxx.
Beginning with Cisco IOS XE 3.11S, the
GigabitEthernet0 interface is no longer
supported.
Note
mgmt-interface
Management gateway address/mask in IPv4 format
for the GigabitEthernet0 management interface.
mgmt-ipv4-addr
IPv4 management default gateway address. If using
DHCP, enter “dhcp” in the field.
mgmt-ipv4-gateway
Configures the IPv4 Network (such as
“192.168.2.0/24” or “192.168.2.0 255.255.255.0”) that
the management gateway should route to. If not
specified, the default route (0.0.0.0/0) is used.
mgmt-ipv4-network
Configures the dot1Q VLAN interface. Requires the
management interface to be configured using the
GigabitEthernetx.xxx format.
mgmt-vlan
(Optional) Configures the Cisco Prime Network
Services Controller service agent SSL port on the
local Cisco CSR 1000v to receive policies from the
service manager.
This setting is used if you plan to remotely manage
the Cisco CSR 1000v using the Cisco Prime Network
Services Controller.
pnsc-agent-local-port
Configures the IP address of the Cisco Prime Network
Services Controller.
This setting is used if you plan to remotely manage
the Cisco CSR 1000v using the Cisco Prime Network
Services Controller.
pnsc-ipv4-addr
Configures the Cisco Prime Network Services
Controller shared secret key for the Cisco Prime
Network Services Controller agent to set the SSL
certificate from the controller.
This setting is used if you plan to remotely manage
the Cisco CSR 1000v using the Cisco Prime Network
Services Controller.
pnsc-shared-secret-key
Configures the password for privileged (enable)
access.
privilege-password
Cisco CSR 1000v Series Cloud Services Router Software Configuration Guide
127
Installing the Cisco CSR 1000v in KVM Environments
Bootstrap Properties

Cisco CSR 1000v Series Specifications

General

Brand	Cisco
Model	CSR 1000v Series
Category	Network Router
Language	English