EasyManuals Logo

Cisco CSR 1000v Series User Manual

Cisco CSR 1000v Series
314 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #288 background imageLoading...
Page #288 background image
DescriptionProperty
Configures the IPv4 management default gateway address. If
using DHCP, enter “dhcp” in the field.
Management IPv4 Gateway (Cisco IOS XE Release 3.12S)
Configures the IPv4 Network (such as “192.168.2.0/24” or
“192.168.2.0 255.255.255.0”) that the management gateway should
route to. If a default route (0.0.0.0/0) is desired, this may be left
blank.
Management IPv4 Network (Cisco IOS XE Release 3.12S)
Table 40: Cisco CSR 1000v OVA Template Bootstrap Properties Required for REST API Support (Cisco IOS XE Release 3.11S and Later)
DescriptionProperty
Designates the management interface for the Cisco CSR 1000v.
The format must be GigabitEthernetx or GigabitEthernetx.xxx.
Management Interface
Configures the IPv4 address and subnet mask for the management
interface.
Management Interface IPv4 Address/Mask
Configures the IPv4 management default gateway address. If
using DHCP, enter “dhcp” in the field.
Management IPv4 Default Gateway
Configures the IP address used for remote management of the
Cisco CSR 1000v by the REST API or by Cisco PNSC. The
address must be in the same subnet as the management interface
address.
Remote Management IPv4 Address(not used if configuring the
shared management interface to support REST API).
Table 41: Cisco CSR 1000v OVA Template Bootstrap Properties Required for REST API Support (Cisco IOS XE Release 3.10S)
DescriptionProperty
Sets the management gateway address and mask in IPv4 format
for the GigabitEthernet0 management interface.
Management IPv4 Address/Mask
Sets the default management gateway IP address in IPv4 format
for the GigabitEthernet0 management interface.
The GigabitEthernet0 interface is no longer supported
beginning in Cisco IOS XE Release 3.11S.
Note
Management IPv4 Default Gateway
Enables an HTTPS server for system configuration and
administration via a web browser. Required if using the REST
API to perform system management in Cisco IOS XE Release
3.10S.
Enable HTTPS Server
Cisco CSR 1000v Series Cloud Services Router Software Configuration Guide
276
Enabling Management by REST API
Enabling REST API Support During Cisco CSR 1000v OVA Deployment

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco CSR 1000v Series and is the answer not in the manual?

Cisco CSR 1000v Series Specifications

General IconGeneral
ModelCSR 1000v Series
CategoryNetwork Router
VirtualizationYes
Form FactorVirtual Appliance
Routing ProtocolsBGP, OSPF, EIGRP, RIP, IS-IS
Minimum Memory4 GB
Minimum vCPUs1
Cloud PlatformsMicrosoft Azure
InterfacesVirtual Interfaces
Supported ProtocolsIPv4, IPv6
VPN ProtocolsIPSec, DMVPN
SecurityIPS
High AvailabilityVRRP, HSRP, GLBP
ManagementNETCONF, RESTCONF, SNMP
Management InterfaceCLI

Related product manuals