Cisco CSR 1000v Series User Manual

This has the same effect as installing a license for that throughput level. For example, on a CSR 1000v with
a 5 Gbps license installed, the following command sets the throughput level to 250 Mbps:
platform hardware throughput level MB 250
The supported throughput levels are: 10 Mbps, 50 Mbps, 100 Mbps, 250 Mbps, 500 Mbps, 1 Gbps, 2.5 Gbps,
5 Gbps, 10 Gbps
For any additional questions, contact your Cisco sales representative.
Obtaining an Evaluation License from the Cisco Licensing Portal
To obtain a 60-day evaluation license for the Cisco CSR 1000v, follow the instructions below.
When the 60-day evaluation license expires, the maximum throughput becomes limited to 100 Kbps upon
reload. For more information, see “Installing CSL Evaluation Licenses for Cisco IOS XE 3.13S and Later”
section on page 9-7 .
These instructions are subject to change.Note
SUMMARY STEPS
1.
Navigate to www.cisco.com/go/license and log in.
2.
Navigate to the Product License Registration Portal.
3.
On the Product License Registration page, select “Continue to Product License Registration.”
4.
Click “Get Other Licenses” and select “Demo and Evaluation” from the dropdown menu.
5.
In the Product Family section, select “Routers & Switches.” In the Product section, select “Cisco Cloud
Services Router 1000v.” Click Next.
6.
Select the desired license type. Enter the UDI Serial number, then click Next to generate the license. You
can display the UDI Serial number on your router by entering the show license udi command.
DETAILED STEPS
Step 1
Navigate to www.cisco.com/go/license and log in.
Step 2
Navigate to the Product License Registration Portal.
Step 3
On the Product License Registration page, select “Continue to Product License Registration.”
Step 4
Click “Get Other Licenses” and select “Demo and Evaluation” from the dropdown menu.
Step 5
In the Product Family section, select “Routers & Switches.” In the Product section, select “Cisco Cloud Services Router
1000v.” Click Next.
Step 6
Select the desired license type. Enter the UDI Serial number, then click Next to generate the license. You can display
the UDI Serial number on your router by entering the show license udi command.
Cisco CSR 1000v Series Cloud Services Router Software Configuration Guide
34
Cisco CSR 1000v Series Cloud Services Router Overview
Evaluation Licenses—Cisco IOS XE 3.13S and Later, Cisco IOS XE Denali 16.3.1 and Later

Cisco CSR 1000v Series Specifications

General

Model	CSR 1000v Series
Category	Network Router
Virtualization	Yes
Form Factor	Virtual Appliance
Routing Protocols	BGP, OSPF, EIGRP, RIP, IS-IS
Minimum Memory	4 GB
Minimum vCPUs	1
Cloud Platforms	Microsoft Azure
Interfaces	Virtual Interfaces
Supported Protocols	IPv4, IPv6
VPN Protocols	IPSec, DMVPN
Security	IPS
High Availability	VRRP, HSRP, GLBP
Management	NETCONF, RESTCONF, SNMP
Management Interface	CLI