Cisco CSR 1000v Series

CommentCommand
Enter ? to display a list of all the interface configuration
commands available for the Gigabit Ethernet interface. This
example shows only some of the available interface configuration
commands.
Router(config-if)# ?
Interface configuration commands:
.
.
.
ip Interface Internet Protocol
config commands
keepalive Enable keepalive
lan-name LAN Name command
llc2 LLC2 Interface Subcommands
load-interval Specify interval for load
calculation for an
interface
locaddr-priority Assign a priority group
logging Configure logging for interface
loopback Configure internal loopback on
an interface
mac-address Manually set interface MAC
address
mls mls router sub/interface commands
mpoa MPOA interface configuration
commands
mtu Set the interface Maximum
Transmission Unit (MTU)
netbios Use a defined NETBIOS access list
or enable
name-caching
no Negate a command or set its
defaults
nrzi-encoding Enable use of NRZI encoding
ntp Configure NTP
.
.
.
Router(config-if)#
Cisco CSR 1000v Series Cloud Services Router Software Configuration Guide
57
Using Cisco IOS XE Software
Finding Command Options