Cisco D9865 User Manual

5-14 D9865 Satellite Receiver Installation and Operation Guide 4035197 Rev C
Setting Up Dish Pointing, Continued
Proceed as follows to set up the dish in Installer Action mode:
1. From the Dish Pointing page, click on the Installer Action link at the bottom
right hand corner of the page.
2. Enter the Satellite Number identifying the saved satellite location, as defined by
the dish motor manufacturer. You can enter a value in the range from 1 to 255.
3. Select the Installer Action. The following table describes the actions available:
Options Description
Continuous West
Movement
Moves the dish west until it reaches its limit.
Ensure that the dish can move to its limit
without any obstructions.
Continuous East
Movement
Moves the dish east until it reaches its limit.
Ensure that the dish can move to its limit
without any obstructions.
Stop Move Stops movement of the dish.
Goto Absolute
Position West
Moves the dish to the Absolute west position
set above.
Goto Absolute
Position East
Moves the dish to the Absolute east position
set above.
Goto Reference Moves the dish to a reference defined by the
dish motor manufacturer.

Cisco D9865 Specifications

General

Brand	Cisco
Model	D9865
Category	Receiver
Language	English