EasyManua.ls Logo

Cisco D9865 - Setting up LNB

Cisco D9865
260 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
4035197 Rev C D9865 Satellite Receiver Installation and Operation Guide 4-23
Setting up LNB
To Set Up LNB Parameters
Proceed as follows to set up the LNB:
1. From the Preset/LNB Setup menu, press the yellow button (LNB) to set up the
LNB.
Note: You can configure up to 10 LNB presets.
2. The following table describes each of the options:
Selection Options Description
LNB Configuration 1 to 10 Number identifying the current preset LNB
configuration.
LNB Power
(For more
information, see LNB
Power Settings, on
page 4-25.)
18-H For H polarization.
13-V For V polarization.
Off Use for external LNB power.
Note: LNB power must be on if DiSEqC is
required.
H-NIT Initially applies the horizontal polarization
voltage, and then follows the polarization based
on the NIT.
V-NIT Initially applies the vertical polarization voltage,
and then follows the polarization based on the
NIT.

Table of Contents

Other manuals for Cisco D9865

Related product manuals