EasyManua.ls Logo

Cisco D9865 - Setting up SI Receive Parameters

Cisco D9865
260 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
5-16 D9865 Satellite Receiver Installation and Operation Guide 4035197 Rev C
Setting up SI Receive Parameters
To Set up the SI Receive Parameters
Proceed as follows to setup the SI Receive parameters:
1. From the user interface of the D9865, click Input > Satellite, expand Tuning
Setup and then click SI Receive Setup. The SI Receive Setup page is displayed.
2. From the Acquisition Mode drop-down list, select the mode used to build
channel lists from allowed service lists. The selections are Auto, Basic, or
Custom. The default is Basic.
If you select Custom, click Configure Custom SI Recv and the Configure
Custom SI Recv window opens:
3. Set the Frequency Tuning Mode, which determines whether the receiver is to
be tuned to the received signal using the NIT or User Cfg (user configurations).

Table of Contents

Other manuals for Cisco D9865

Related product manuals