4035197 Rev C D9865 Satellite Receiver Installation and Operation Guide 4-63
Configuring Noise Cutoffs
Setting the Noise Cutoff parameters
The Noise Cutoffs screen allows you to set the muting thresholds for both audio
and video in the event of a noisy signal.
Proceed as follows to configure the noise cutoffs:
1. From the Advanced Setup screen, select Noise Cutoffs and press OK. A
message appears confirming that you want to edit the noise cutoffs.
2. Select Yes to edit. Otherwise, select No.
3. The following table describes each of the options:
Selection Options Description Default
Noise Cutoffs Enable or
Disable
Sets whether to enable or disable the noise
cutoffs functionality.
Enable
To Next Page
Loading...
