5-48 D9865 Satellite Receiver Installation and Operation Guide 4035197 Rev C
Setting Up SNMP and Trap Destinations
To Set Up SNMP
Proceed as follows to configure the SNMP settings:
1. From the user interface of the D9865, click System Settings > System, expand IP
Settings and then click SNMP. The SNMP page is displayed.
2. Set the Read Community String and the Write Community String to public or
a custom string. The SNMP Community Read/Write is used when
communicating with a device within an SNMP environment. These commands
allow you to set the password to read and write data to a device to display
diagnostics traps/alarms. The default community string is public. To set a
custom community string, enter an alphanumeric character string up to 31-
characters in length identifying the password for the device.
Note: The community string is case-sensitive.
3. Enter the System Name, System Location, and System Contact information of
the D9865. The system information is sent to the MIB browser, if applicable. The
MIB Browser is a third party software used to manage SNMP requests. For more
information, contact Cisco customer support.
4. The Trap Destination Configuration section displays a list of trap destination
address and the associated community string.
To Next Page
Loading...
Need help?
General
