4-50 D9865 Satellite Receiver Installation and Operation Guide 4035197 Rev C
Setting up POV Mode
To Set Up the POV Mode
Proceed as follows to configure the POV Mode:
Note: Ensure the POV Mode setting is set to Advanced.
1. From the Administration screen, press the blue button (POVAdv).
2. Select the Conditional Access type (CA Mode) that determines which programs
can be viewed via the satellite receiver. Select Std (preferred) or Open. The
default is Std.
Important: In Open mode, the receiver ignores inconsistent scrambling
descriptions within the signal. Operating in this mode may cause the decoder
not to respond to certain advanced uplink controlled features, such as service
replacement.
3. Set the Acquisition Mode used to build channel lists from allowed service lists
(Basic, Auto, or Custom). Select Custom to customize the tables used to obtain
tuning and channel lists.
4. If the Acquisition Mode was set to Custom, you can set the Tuning Source to
indicate whether the receiver is tuned to the received signal using the NIT or a
Preset. The default is NIT.
To Next Page
Loading...
Need help?
General
