Cisco D9865 User Manual

4035197 Rev C D9865 Satellite Receiver Installation and Operation Guide 5-55
Setting Up Alarms and Warnings, Continued
To Set up Warnings
Proceed as follows to set up the warnings:
1. From the Setup - Alarm Setup page, click on the Warning Setup link at the
bottom left hand corner of the page. The Setup - Warning Setup page is
displayed.
2. The Warning Setup section displays a list of alarm/fault messages. For more
information on alarm messages, refer to Messages, on page 7-2.
3. Set Enable/Disable to Yes and the warning message will be reported. Set to No
and the fault won’t be reported.
4. Set Trap to Yes and the SNMP trap message will be sent to the trap destination;
otherwise the fault message will be ignored.
Note: This is for D9865D only.
5. Click on the Trap Configuration link to view and/or modify trap destinations.
The link will open the SNMP page. For more information, refer to Setting Up
SNMP and Trap Destinations, on page 5-48.
6. Click Apply.

Cisco D9865 Specifications

General

Brand	Cisco
Model	D9865
Category	Receiver
Language	English