4-32 D9865 Satellite Receiver Installation and Operation Guide 4035197 Rev C
Setting Up the Satellite Dish, Continued
Signal Lock
The Signal Lock status is continuously updated to indicate whether the receiver is
synchronized with the received satellite RF signal. Signal Lock status is displayed
on the Preset / LNB Setup and Dish Setup menus.
If the receiver is able to synchronize to a carrier frequency and an MPEG stream is
present, Signal Lock displays Lock and the Signal LED on the receiver front panel
is on. If no carrier is detected, Signal Lock displays No Lock and the Signal LED is
off.
To Next Page
Loading...
