Contents
vii
Cisco IOS Software Configuration Guide for Cisco Aironet Access Points
OL-14209-01
Default Banner Configuration 5-35
Configuring a Message-of-the-Day Login Banner 5-35
Configuring a Login Banner 5-37
Upgrading Autonomous Cisco Aironet Access Points to Lightweight Mode 5-37
Migrating to Japan W52 Domain 5-37
Verifying the Migration 5-39
Configuring Multiple VLAN and Rate Limiting for Point-to-Multipoint Bridging 5-39
CLI Command 5-40
Configuring Radio Settings 6-1
Enabling the Radio Interface 6-2
Configuring the Role in Radio Network 6-2
Universal Workgroup Bridge Mode 6-5
Configuring Dual-Radio Fallback 6-5
Radio Tracking 6-6
Fast Ethernet Tracking 6-6
MAC-Address Tracking 6-6
Bridge Features Not Supported 6-7
Configuring Radio Data Rates 6-7
Access Points Send Multicast and Management Frames at Highest Basic Rate 6-8
Configuring MCS Rates 6-10
Configuring Radio Transmit Power 6-11
Limiting the Power Level for Associated Client Devices 6-13
Configuring Radio Channel Settings 6-14
802.11n Channel Widths 6-15
Dynamic Frequency Selection 6-16
CLI Commands 6-18
Confirming that DFS is Enabled 6-18
Configuring a Channel 6-19
Blocking Channels from DFS Selection 6-19
Setting the 802.11n Guard Interval 6-20
Configuring Location-Based Services 6-21
Understanding Location-Based Services 6-21
Configuring LBS on Access Points 6-21
Enabling and Disabling World Mode 6-22
To Next Page
Loading...
