RP/0/RP0/CPU0:router(config-GRP-if)# mtu 2000
RP/0/RP0/CPU0:router(config-GRP-if)# end-group
When this configuration group is committed, the MTU configuration for interface GigabitEthernet0/4/1/0 is
automatically updated to 2000.
Configuration Examples for Flexible CLI Configuration
Basic Flexible CLI Configuration: Example
This example shows that the Media Access Control (MAC) accounting configuration from the gd21
configuration group is applied to all Gigabit Ethernet interfaces in slot 2, ports 1 to 9.
1
Configure the configuration group that configures MAC accounting:
RP/0/RP0/CPU0:router# show running group gd21
group gd21
interface 'GigabitEthernet0/0/0/2[1-9]'
description general interface inheritance check
load-interval 30
mac-accounting ingress
mac-accounting egress
!
end-group
2
Check that the corresponding apply-group is configured in global configuration or somewhere in the
hierarchy:
RP/0/RP0/CPU0:router# show running | in apply-group gd21
Building configuration...
apply-group gd21
3
Check the concise local view of the configuration of some of the interfaces:
RP/0/RP0/CPU0:router# show running interface
interface GigabiEthernet0/0/0/21
!
interface GigabitEthernet0/0/0/22
!
4
Verify that the match and inheritance occur on these interfaces:
RP/0/RP0/CPU0:router# show running-config inheritance interface
interface GigabitEthernet0/0/0/21
## Inherited from group gd21
description general interface inheritance check
## Inherited from group gd21
load-interval 30
## Inherited from group gd21
mac-accounting ingress
## Inherited from group gd21
mac-accounting egress
!
Interface GigabitEthernet0/0/0/22
## Inherited from group gd21
description general interface inheritance check
## Inherited from group gd21
System Management Configuration Guide for Cisco NCS 5000 Series Routers, IOS XR Release 6.2.x
93
Configuring Flexible Command Line Interface
Configuration Examples for Flexible CLI Configuration
To Next Page
Loading...
Need help?
General
