•
Use of preconfigured interfaces in configuration groups is not supported.
•
Downgrading from an image that supports configuration groups to an image that does not support them
is not supported.
•
Access lists, quality of service and route policy configurations do not support the use of configuration
groups. Configurations such as these are not valid:
group g-not-supported
ipv4 access-list ...
!
ipv6 access-list ...
!
ethernet-service access-list ...
!
class-map ...
!
policy-map ...
!
route-policy ...
!
end-group
You can, however, reference such configurations, as shown in this example:
group g-reference-ok
router bgp 6500
neighbor 7::7
remote-as 65000
bfd fast-detect
update-source Loopback300
graceful-restart disable
address-family ipv6 unicast
route-policy test1 in
route-policy test2 out
soft-reconfiguration inbound always
!
!
!
interface Bundle-Ether1005
bandwidth 10000000
mtu 9188
service-policy output input_1
load-interval 30
!
end-group
• Some regular expressions are not supported within groups. For example, ‘?’, ‘|’ and ‘$,’ are not supported
within groups. Also some characters such as /d and /w are not supported.
◦ The choice operator “|” to express multiple match expressions within a regular expression is not
supported. For example, these expressions are not supported:
Gig.*|Gig.*\..*—To match on either Gigabit Ethernet main interfaces or Gigabit Ethernet
sub-interfaces.
Gig.*0/0/0/[1-5]|Gig.*0/0/0/[10-20]—To match on either Gig.*0/0/0/[1-5] or
Gig.*0/0/0/[10-20].
'TenGigE.*|HundredGigE.*—To match on either TenGigE.* or HundredGigE.* .
•
Commands that require a node identifier for the location keyword are not supported. For example, this
configuration is not supported:
lpts pifib hardware police location 0/RP0/CPU0
System Management Configuration Guide for Cisco NCS 5000 Series Routers, IOS XR Release 6.2.x
78
Configuring Flexible Command Line Interface
Flexible Configuration Restrictions
To Next Page
Loading...
Need help?
General
