EasyManuals Logo

Cisco NCS 5000 Series User Manual

Cisco NCS 5000 Series
188 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #37 background imageLoading...
Page #37 background image
In this illustration, the agent sends a trap to the manager, but the trap does not reach the manager. Because
the agent has no way of knowing that the trap did not reach its destination, the trap is not sent again. The
manager never receives the trap.
Figure 3: Trap Not Received by the SNMP Manager
Session Types
The supported session types are:
PPPoE
IP SUB PKT
IP SUB DHCP
How to Implement SNMP on Cisco IOS XR Software
This section describes how to implement SNMP.
The snmp-server commands enable SNMP on Management Ethernet interfaces by default. For information
on how to enable SNMP server support on other inband interfaces, see the Implementing Management Plane
Protection on Cisco IOS XR Software module in System Security Configuration Guide for Cisco NCS 5000
Series Routers.
Configuring SNMPv3
This task explains how to configure SNMPv3 for network management and monitoring.
No specific command enables SNMPv3; the first snmp-server global configuration command (config),
that you issue enables SNMPv3. Therefore, the sequence in which you issue the snmp-server commands
for this task does not matter.
Note
System Management Configuration Guide for Cisco NCS 5000 Series Routers, IOS XR Release 6.2.x
27
Implementing SNMP
Session Types

Table of Contents

Other manuals for Cisco NCS 5000 Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco NCS 5000 Series and is the answer not in the manual?

Cisco NCS 5000 Series Specifications

General IconGeneral
BrandCisco
ModelNCS 5000 Series
CategoryNetwork Router
LanguageEnglish

Related product manuals