Cisco NCS 5000 Series User Manual

Modifying Global CDP Settings: Example
The following example shows how to modify global CDP settings. In this example, the timer setting is set to
20 seconds, the hold-time setting is set to 30 seconds, and the version of CDP used to communicate with
neighboring devices is set to CDPv1:
cdp timer 20
cdp holdtime 30
cdp advertise v1
The following example shows how to use the show cdp command to verify the CDP global settings:
RP/0/RP0/CPU0:router# show cdp
Global CDP information:
Sending CDP packets every 20 seconds
Sending a holdtime value of 30 seconds
Sending CDPv2 advertisements is not enabled
Additional References
The following sections provide references related to implementing CDP on Cisco IOS XR software.
Related Documents
Document TitleRelated Topic
CDP Commands on Cisco IOS XR Software module
of System Management Command Reference for
Cisco NCS 5000 Series Routers
Cisco IOS XR CDP commands
Cisco IOS XR commands
Getting started with Cisco IOS XR Software
Configuring AAA Services on Cisco IOS XR Software
module of System Security Configuration Guide for
Cisco NCS 5000 Series Routers
Information about user groups and task IDs
Standards
TitleStandards
—
No new or modified standards are supported by this
feature, and support for existing standards has not
been modified by this feature.
System Management Configuration Guide for Cisco NCS 5000 Series Routers, IOS XR Release 6.2.x
64
Implementing CDP
Additional References

Cisco NCS 5000 Series Specifications

General

Brand	Cisco
Model	NCS 5000 Series
Category	Network Router
Language	English