Cisco NCS 5000 Series User Manual

1 Internal0 [0/RP0/CPU0] n/a ST3 255 Available
Selection point: T4-SEL-A (0 inputs, 0 selected)
Last programmed 4w0d ago, and selection made 2d23h ago
Next selection points
SPA scoped : None
Node scoped : None
Chassis scoped: None
Router scoped : None
Uses frequency selection
Selection point: T4-SEL-C (0 inputs, 0 selected)
Last programmed 4w0d ago, and selection made 2d23h ago
Next selection points
SPA scoped : None
Node scoped : None
Chassis scoped: None
Router scoped : None
Uses frequency selection
Selection point: CHASSIS-TOD-SEL (0 inputs, 0 selected)
Last programmed 4w0d ago, and selection made 4w0d ago
Next selection points
SPA scoped : None
Node scoped : None
Chassis scoped: None
Router scoped : None
Uses time-of-day selection
Selection point: NCS5K_ETH_RXMUX (0 inputs, 0 selected)
Last programmed 4d03h ago, and selection made 4d03h ago
Next selection points
SPA scoped : None
Node scoped : T0-SEL-B
Chassis scoped: None
Router scoped : None
Uses frequency selection
To display a summary of the frequency synchronization configuration, use show frequency synchronization
summary command.
RP/0/RP0/CPU0:router# show frequency synchronization summary
Fri Apr 7 15:06:24.123 UTC
Frequency
=========
Internal0 [0/RP0/CPU0] is driving frequency on:
0 Clock-interfaces
4 Ethernet interfaces
0 SONET interfaces
Time-of-Day
=========
Configuring Frequency Synchronization on an Interface
To configure Frequency Synchronization on an Interface, use the following procedure:
By default, there is no Frequency Synchronization on a line Interface. Frequency Synchronization must
be enabled globally on the router prior to configuring Frequency Synchronization on an interface.
Note
System Management Configuration Guide for Cisco NCS 5000 Series Routers, IOS XR Release 6.2.x
174
Frequency Synchronization
Configuring Frequency Synchronization on an Interface

Cisco NCS 5000 Series Specifications

General

Brand	Cisco
Model	NCS 5000 Series
Category	Network Router
Language	English