Cisco NCS 5000 Series User Manual

PurposeCommand or Action
(Optional)
Sets the maximum packet size.
snmp-server packetsize byte-count
Example:
RP/0/RP0/CPU0:router(config)# snmp-server packetsize
1024
Step 2
commit
Step 3
Changing Notification Operation Values
After SNMP notifications have been enabled, you can specify a value other than the default for the source
interface, message queue length, or retransmission interval.
This task explains how to specify a source interface for trap notifications, the message queue length for each
host, and the retransmission interval.
The sequence in which you issue the snmp-server commands for this task does not matter.Note
SUMMARY STEPS
1.
configure
2.
(Optional) snmp-server trap-source type interface-path-id
3.
(Optional) snmp-server queue-length length
4.
(Optional) snmp-server trap-timeout seconds
5.
commit
DETAILED STEPS
PurposeCommand or Action
configure
Step 1
(Optional)
Specifies a source interface for trap notifications.
snmp-server trap-source type interface-path-id
Example:
RP/0/RP0/CPU0:router(config)# snmp-server trap-source
POS 0/0/1/0
Step 2
System Management Configuration Guide for Cisco NCS 5000 Series Routers, IOS XR Release 6.2.x
37
Implementing SNMP
Changing Notification Operation Values

Cisco NCS 5000 Series Specifications

General

Brand	Cisco
Model	NCS 5000 Series
Category	Network Router
Language	English