Cisco NCS 5000 Series User Manual

PurposeCommand or Action
(Optional)
Establishes the message queue length for each
notification.
snmp-server queue-length length
Example:
RP/0/RP0/CPU0:router(config)# snmp-server
queue-length 20
Step 3
(Optional)
Defines how often to resend notifications on the
retransmission queue.
snmp-server trap-timeout seconds
Example:
RP/0/RP0/CPU0:router(config)# snmp-server
trap-timeout 20
Step 4
commit
Step 5
Setting IP Precedence and DSCP Values
This task describes how to configure IP Precedence or IP DSCP for SNMP traffic.
Before You Begin
SNMP must be configured.
SUMMARY STEPS
1.
configure
2.
Use one of the following commands:
•
snmp-server ipv4 precedence value
•
snmp-server ipv4 dscp value
3.
commit
DETAILED STEPS
PurposeCommand or Action
configure
Step 1
Configures an IP precedence or IP DSCP
value for SNMP traffic.
Use one of the following commands:
Step 2
•
snmp-server ipv4 precedence value
•
snmp-server ipv4 dscp value
System Management Configuration Guide for Cisco NCS 5000 Series Routers, IOS XR Release 6.2.x
38
Implementing SNMP
Setting IP Precedence and DSCP Values

Cisco NCS 5000 Series Specifications

General

Brand	Cisco
Model	NCS 5000 Series
Category	Network Router
Language	English