Cisco NCS 5000 Series User Manual

----------------------------------------------------------------------------------------------
SPA-1X10GE-L-V2 SPA FPGA swv1.9 spa fpga1 1.09 0.00 0.0
----------------------------------------------------------------------------------------------
SPA-4XOC3-POS-V2 SPA FPGA swv1.0 spa fpga1 1.00 0.00 0.5
----------------------------------------------------------------------------------------------
SPA-1X10GE-WL-V2 SPA FPGA swv1.9 spa fpga1 1.09 0.00 0.0
----------------------------------------------------------------------------------------------
SPA-1XOC3-ATM-V2 SPA FPGA swv1.2 spa fpga1 2.02 0.00 0.0
----------------------------------------------------------------------------------------------
SPA-2XOC3-ATM-V2 SPA FPGA swv1.2 spa fpga1 2.02 0.00 0.0
----------------------------------------------------------------------------------------------
SPA-3XOC3-ATM-V2 SPA FPGA swv1.2 spa fpga1 2.02 0.00 0.0
----------------------------------------------------------------------------------------------
SPA-1XOC12-ATM-V2 SPA FPGA swv1.2 spa fpga1 2.02 0.00 0.0
----------------------------------------------------------------------------------------------
This example shows the fpd details of the A9K-MOD400-SE:
RP/0/RP0/CPU0:router # show hw-module fpd location 0/2/CPU0
===============================================================================
Existing Field Programmable Devices
===============================================================================
HW Current SW Upg/
Location Card Type Version Type Subtype Inst Version Dng?
============ ======================== ======= ==== ======= ==== =========== ====
0/2/CPU0 A9K-MOD400-SE 1.0 lc cbc 0 39.05 No
lc rommon 0 8.32 No
lc fpga2 0 1.30 Yes
lc fsbl 0 1.19 Yes
lc lnxfw 0 1.20 Yes
lc fpga10 0 1.17 No
--------------------------------------------------------------------------------
In the show fpd package command output, the “subtype” column shows the FPDs that correspond with
each SPA image. To upgrade a specific FPD with the upgrade hw-module fpd command, replace the
fpga-type argument with the appropriate FPD from the “subtype” column, as shown in the following
example:
RP/0/RP0/CPU0:router(admin)# upgrade hw-module fpd fpga2 location 0/3/1 reload
Note
upgrade hw-module fpd Command Output: Example
Use the upgrade hw-module fpd command to upgrade the FPD image on a SPA, SIP or line card.
show platform Command Output: Example
Use the show platform command to verify that the SPA is up and running.
System Management Configuration Guide for Cisco NCS 5000 Series Routers, IOS XR Release 6.2.x
144
Upgrading FPD
upgrade hw-module fpd Command Output: Example

Cisco NCS 5000 Series Specifications

General

Brand	Cisco
Model	NCS 5000 Series
Category	Network Router
Language	English