Cisco NCS 5000 Series User Manual

PurposeCommand or Action
Do you want to continue? [Confirm(y/n)]
If you confirm that you want to abort the FPD upgrade
procedure, this message is displayed:
FPD upgrade process has been aborted, please
check the status of the hardware and reissue
the upgrade command if required.
If your card supports multiple FPD images, you
can use the show fpd package admin command
to determine what specific image to upgrade in the
upgrade hw-module fpd command.
Note
Exits administration EXEC mode and returns to EXEC
mode.
exit
Example:
RP/0/RP0/CPU0:router(admin)# exit
Step 5
Use the hw-module subslot reload command to reload a
SPA and the hw-module location reload command to
reload a SIP or line card.
hw-module {location node-id | subslot subslot-id} reload
Example:
RP/0/RP0/CPU0:router# hw-module subslot 0/3/1 reload
Step 6
Only use this command if you do not use the
reload keyword in the upgrade hw-module fpd
command.
Note
or
RP/0/RP0/CPU0:router# hw-module location 0/3/cpu0
reload
Verifies that the FPD image on the card has been
successfully upgraded by displaying the status of all cards
in the system.
show platform
Example:
RP/0/RP0/CPU0:router# show platform
Step 7
Configuration Examples for FPD Image Upgrade
The following examples indicates the use of commands associated with the FPD image upgrade procedure.
show hw-module fpd Command Output: Example
Use the show hw-module fpd to display the current version of FPD images on the SPAs, SIPs and other cards
installed on your router.
This command can be used to identify information about FPDs on any card. If you enter the location of a line
card that is not a SPA, the output displays information about any programmable devices on that line card.
System Management Configuration Guide for Cisco NCS 5000 Series Routers, IOS XR Release 6.2.x
112
Upgrading FPD
Configuration Examples for FPD Image Upgrade

Cisco NCS 5000 Series Specifications

General

Brand	Cisco
Model	NCS 5000 Series
Category	Network Router
Language	English