Cisco NCS 5000 Series User Manual

DETAILED STEPS
PurposeCommand or Action
configure
Step 1
Enters NTP configuration mode.ntp
Example:
RP/0/RP0/CPU0:router(config)# ntp
Step 2
Disables NTP services on the specified interface.Use one of the following commands:
Step 3
•
no interface type interface-path-id
•
interface type interface-path-id disable
Example:
RP/0/RP0/CPU0:router(config-ntp)# no
interface pos 0/0/0/1
or
RP/0/RP0/CPU0:router(config-ntp)# interface
POS 0/0/0/1 disable
Saves configuration changes.Use one of the following commands:
Step 4
•
end
•
When you issue the end command, the system prompts you
to commit changes:
Uncommitted changes found, commit them before
•
commit
Example:
RP/0/RP0/CPU0:router(config-ntp)# end
exiting(yes/no/cancel)?
[cancel]:
◦
Entering yes saves configuration changes to the running
configuration file, exits the configuration session, and
returns the router to EXEC mode.
or
RP/0/RP0/CPU0:router(config-ntp)# commit
◦
Entering no exits the configuration session and returns
the router to EXEC mode without committing the
configuration changes.
◦
Entering cancel leaves the router in the current
configuration session without exiting or committing the
configuration changes.
•
Use the commit command to save the configuration changes
to the running configuration file and remain within the
configuration session.
System Management Configuration Guide for Cisco NCS 5000 Series Routers, IOS XR Release 6.2.x
156
Implementing NTP
Disabling NTP Services on a Specific Interface

Cisco NCS 5000 Series Specifications

General

Brand	Cisco
Model	NCS 5000 Series
Category	Network Router
Language	English