Cisco NCS 5000 Series User Manual

Verifying the Identification of the Local SNMP Engines
This example shows how to verify the identification of the local SNMP engine:
config
show snmp engineid
SNMP engineID 00000009000000a1ffffffff
Creating a View
There are two ways to create a view:
•
You can include the object identifier (OID) of an ASN.1 subtree of a MIB family from a view by using
the included keyword of the snmp-server view command.
•
You can exclude the OID subtree of the ASN.1 subtree of a MIB family from a view by using the
excluded keyword of the snmp-server view command.
This example shows how to create a view that includes the sysName (1.3.6.1.2.1.1.5) object:
config
snmp-server view SNMP_VIEW1 1.3.6.1.2.1.1.5 included
This example shows how to create a view that includes all the OIDs of a system group:
config
snmp-server view SNMP_VIEW1 1.3.6.1.2.1.1 included
This example shows how to create a view that includes all the OIDs under the system group except the sysName
object (1.3.6.1.2.1.1.5), which has been excluded:
config
snmp-server view SNMP_VIEW1 1.3.6.1.2.1.1 included
snmp-server view SNMP_VIEW1 1.3.6.1.2.1.1.5 excluded
Verifying Configured Views
This example shows how to display information about the configured views:
RP/0/RP0/CPU0:router# show snmp view
v1default 1.3.6.1 - included nonVolatile active
SNMP_VIEW1 1.3.6.1.2.1.1 - included nonVolatile active
SNMP_VIEW1 1.3.6.1.2.1.1.5 - excluded nonVolatile active
Creating Groups
If you do not explicitly specify a notify, read, or write view, the Cisco IOS XR software uses the v1 default
(1.3.6.1). This example shows how to create a group that utilizes the default view:
RP/0/RP0/CPU0:router# snmp-server group group-name v3 auth
System Management Configuration Guide for Cisco NCS 5000 Series Routers, IOS XR Release 6.2.x
30
Implementing SNMP
Configuring SNMPv3: Examples

Cisco NCS 5000 Series Specifications

General

Brand	Cisco
Model	NCS 5000 Series
Category	Network Router
Language	English