Cisco NCS 5000 Series User Manual

show hw-module fpd Command Output: Example 112
show fpd package Command Output: Example 114
upgrade hw-module fpd Command Output: Example 144
show platform Command Output: Example 144
CHAPTER 10 Implementing NTP 145
Prerequisites for Implementing NTP on Cisco IOS XR Software 145
Information About Implementing NTP 145
NTP-PTP Interworking 146
Configuring Poll-Based Associations 147
Configuring Broadcast-Based NTP Associates 149
Configuring NTP Access Groups 151
Configuring NTP Authentication 153
Disabling NTP Services on a Specific Interface 155
Configuring the Source IP Address for NTP Packets 157
Configuring the System as an Authoritative NTP Server 158
Configuring NTP-PTP Interworking 159
Updating the Hardware Clock 161
Verifying the Status of the External Reference Clock 162
Examples 163
Configuration Examples for Implementing NTP 164
Configuring NTP server inside VRF interface 166
Additional References 168
CHAPTER 11 Frequency Synchronization 171
Using Synchronous Ethernet for Frequency Synchronization 171
Restrictions 172
Configuring Frequency Synchronization 172
Configuring Frequency Synchronization on an Interface 174
System Management Configuration Guide for Cisco NCS 5000 Series Routers, IOS XR Release 6.2.x
vii
Contents

Cisco NCS 5000 Series Specifications

General

Brand	Cisco
Model	NCS 5000 Series
Category	Network Router
Language	English