a) Unscrew the screw on the center of each of the two handles on the fabric module (see Callout 1 in the following
figure).
Rotate both ejector handles away from the front of
the fabric module.
2Unscrew 2 captive screws (1 on each ejector
handle).
1
b) Rotate the two handles at least 30 degrees so that the other end of each handle no longer holds the module in the slot
(see Callout 2 in the previous figure).
c) With each of the two handles in your two hands, pull the module a couple of inches (about 5 cm) out of the slot (see
the following figure).
Cisco Nexus 9508 NX-OS Mode Switch Hardware Installation Guide
95
Replacing or Installing Modules, Fan Trays, and Power Supplies
Removing a Fabric Module
To Next Page
Loading...
