EasyManuals Logo

Cisco SG350-10MP Administration Guide

Cisco SG350-10MP
762 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #102 background imageLoading...
Page #102 background image
Administration
User Accounts
Cisco 350, 350X and 550X Series Managed Switches, Firmware Release 2.4, ver 0.4 79
6
NOTE For information on password recover, see Menu CLI and Password Recovery.
To add a new user:
STEP 1 Click Administration > User Accounts.
This page displays the users defined in the system and their user privilege level.
STEP 2 Click Add to add a new user or click Edit to modify a user.
STEP 3 Enter the parameters.
User Name—Enter a new username between 0 and 20 characters. UTF-8 characters are
not permitted.
Password—Enter a password (UTF-8 characters are not permitted). If the password
strength and complexity is defined, the user password must comply with the policy
configured in Password Strength.
Confirm Password—Enter the password again.
Password Strength Meter—Displays the strength of password. The policy for
password strength and complexity are configured in the Password Strength page.
User Level—Select the privilege level of the user being added/edited.
- Read-Only CLI Access (1)—User cannot access the GUI, and can only access CLI
commands that do not change the device configuration.
- Read/Limited Write CLI Access (7)—User cannot access the GUI, and can only
access some CLI commands that change the device configuration. See the CLI
Reference Guide for more information.
- Read/Write Management Access (15)—User can access the GUI, and can configure
the device.
STEP 4 Click Apply. The user is added to the Running Configuration file of the device.

Table of Contents

Other manuals for Cisco SG350-10MP

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco SG350-10MP and is the answer not in the manual?

Cisco SG350-10MP Specifications

General IconGeneral
ModelSG350-10MP
CategorySwitch
PoE Budget130W
Switching Capacity20 Gbps
Forwarding Rate14.88 Mpps
Power SupplyInternal
Ports8 x 10/100/1000 PoE+ + 2 x Gigabit SFP
MAC Address Table Size16K
Jumbo Frame Support9216 bytes
ManagementWeb-based, CLI, SNMP
Operating Temperature0°C to 45°C (32°F to 113°F)
Storage Temperature-20°C to 70°C (-4°F to 158°F)
Operating Humidity10% to 90% relative humidity, non-condensing
Storage Humidity5% to 95% relative humidity, non-condensing
Dimensions (W x D x H)279.4 x 170 x 44 mm (11.0 x 6.7 x 1.73 in)

Related product manuals